Arduino Sensor Shield — V5 0 Manual

is a plug-and-play expansion board designed to simplify the connection of sensors, servos, and modules to microcontrollers like the Arduino Uno or Mega 2560 . It eliminates the need for breadboards by organizing I/O pins into standardized 3-pin headers consisting of , Voltage (VCC) , and Ground (G) . Technical Specifications Compatible Boards Arduino Uno, Mega, Leonardo Digital I/O Ports 13 (D0–D13) with dedicated VCC and GND Analog I/O Ports 6 (A0–A5) with dedicated VCC and GND Communication I2C, SPI, UART (Serial), Bluetooth, APC220 Special Interfaces SD Card, Ultrasonic (URF), LCD (Serial & Parallel) Dimensions 57mm x 57mm Key Features and Interfaces Shields & Carriers - Arduino Store

The Sensor Shield V5.0 is a passive expansion board designed specifically for the (as well as the Arduino Leonardo and similar form factors). It sits directly on top of your Arduino, stacking via the standard headers.

Connect a 5V external power battery pack to the screw terminal block (observe correct polarity). Take the 3-pin connector of the SG90 servo.

: Isolates the Arduino's built-in power supply from the shield's VCC rows. You must connect an external 5V to 12V power supply to the blue screw terminal block. ⚠️ Critical Warning for Servo Motors arduino sensor shield v5 0 manual

Here is a quick test to ensure your shield is working. Plug a standard LED into (Signal, 5V, GND). Run this code:

Digital pins 3, 5, 6, 9, 10, and 11 support pulse‑width modulation (PWM), which is essential for controlling the brightness of an LED, the speed of a DC motor, or the position of a servo motor. On the Arduino UNO and similar boards, these are the pins marked with a ~ symbol. The shield preserves this capability on the matching headers.

: Located along the bottom edge. Perfect for analog sensors like potentiometers or light sensors. 2. Specialized Communication Ports is a plug-and-play expansion board designed to simplify

The is an expansion board designed to simplify connections between Arduino (Uno R3, Leonardo, or compatible boards) and various sensors, servos, and communication modules. Instead of messy breadboard jumper wires, this shield provides labeled, standardized interfaces (3-pin, 4-pin, I2C, Serial, etc.).

: The SEL jumper is still attached. Remove it and connect an external power supply to the screw terminals.

The Sensor Shield V5.0 preserves the footprint of the standard Arduino Uno while multiplying its connection capacity. It sits directly on top of your Arduino,

The Sensor Shield V5.0 features an external power terminal block (labeled ) and a crucial jumper cap labeled SEL . Understanding this jumper protects your Arduino from drawing too much current.

If you can tell me what specific sensor or motor you are trying to connect, I can provide a wiring diagram and example code. Arduino Sensor Shield V5.0