Always operate the radio on its internal battery rather than keeping it plugged into a USB wall charger while listening.
If you want to listen to Ham Radio operators, you must switch to or LSB (Lower Sideband) . Find the frequency (e.g., 7.175 MHz for 40m ham band). Switch mode to LSB. Press the BFO button.
Wait for the "Upload Successful" prompt. The radio will reboot into a completely revised, high-performance interface. 6. Troubleshooting and Maintenance Reference ats20 radio manual better
Press the button to select your tuning resolution. For sweeping through shortwave, a 5 kHz step is standard. For SSB ham operators, drop it down to 1 kHz. Rotate the encoder knob to find a station. How to Properly Clear Up SSB (Single Sideband) Signals
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Always operate the radio on its internal battery
When you long-press the encoder knob, you enter the configuration menu. The factory manual often fails to explain what these settings actually do. Here is the translation:
More detailed signal strength meters (RSSI) and Signal-to-Noise Ratio (SNR) readouts. Switch mode to LSB
for improved shortwave reception.