Core-Gateway# copy tftp: flash: Address or name of remote host []? 10.1.1.50 Source filename []? c3560-ipbasek9-mz.122-58.SE2.bin Destination filename [c3560-ipbasek9-mz.122-58.SE2.bin]? Use code with caution.

: Plug in the AC or DC power cables. Use the power cord retainer if available.

The Cisco 8500 Series Secure Routers can be mounted in a 2-post or 4-post 19-inch/23-inch rack.

: If the router is at factory defaults, it may prompt you to start the "Initial Configuration Dialog." If you are locked out, you can perform a password recovery by entering ROMMON mode (repeatedly pressing Ctrl+Break during boot) and changing the configuration register to 0x2142 to ignore the startup config. Software Installation (Cisco IOS)

: Plug the power cord into the locking power socket on the rear of the device and connect it to a grounded AC outlet. Confirm the PWR LED on the front panel turns solid green. Initial Software Configuration

Ensure you have a console cable, a TFTP server (like Tftpd64), and the correct IOS image file.

: Introduces keywords for aaa common-criteria policy to restrict consecutive letters and repetitions.

If "1710" refers to the release, follow these steps for a consolidated package installation. Hardware Installation Guide for Cisco 8500 Switches

Would you like to enter the initial configuration dialog? [yes/no]: yes System Name [Cisco_85xx]: WLC-8510 Management Interface IP Address: 192.168.1.10 Management Interface Netmask: 255.255.255.0 Management Interface Default Gateway: 192.168.1.1 Management Interface VLAN Identifier (0 = untagged): 0 Enable SSH/HTTP/HTTPS? yes

: Connect an operational management Ethernet cable or an RJ-45 roll-over console cable to the dedicated front-panel management interface. 2. Setting Up the Console Session

Insert and tighten the rack screws through the bracket holes into the rack posts, securing the bottom screws first to stabilize the weight. 3. Cabling and Physical Connections