Egs002 Proteus Library Upd Today

| Feature | Description | |---------|-------------| | | Configurable 50Hz or 60Hz via on‑board jumper | | Output Waveform | Pure sine wave (SPWM) | | Protections | Over‑voltage, under‑voltage, over‑current, over‑temperature | | Soft Start | 3‑second soft‑start to reduce in‑rush current | | Dead Time | Selectable 300ns, 500ns, 1µs, or 1.5µs | | LCD Interface | Connector for 12832 serial LCD to display voltage, current, frequency, and temperature | | Supply Voltage | +5V (logic) and +15V ~ +20V (driver stage) | | Standby Power | Less than 1W | | Max Output Power | Approximately 300W (scalable with external MOSFETs) |

Observe how the control block adjusts the SPWM duty cycle to regulate and maintain a steady output voltage. Troubleshooting Common Simulation Issues

The is a popular choice for DIY power electronics, but it is not natively included in standard Proteus software libraries. To simulate it, you must either find a third-party library or import a custom schematic symbol and footprint. How to Add the EGS002 Library to Proteus egs002 proteus library

Once installed, you can find the device by pressing in the schematic capture window and typing "EGS002." 1. Basic Circuit Setup

Key features of the hardware include:

You cannot find "EGS002" in the component picker of Proteus 8 or Proteus 9 out-of-the-box.

The fault pin ( FLT ) is active. Fix: Pull the FLT pin to GND through a 10k resistor. Also check that the crystal/oscillator in the simulation settings is active. | Feature | Description | |---------|-------------| | |

Comprehensive Guide to Integrating the EGS002 SPWM Driver Board in Proteus

If you cannot find or install the library, here are workarounds: How to Add the EGS002 Library to Proteus