Contains dimensional drawings showing the base plate footprint (approx. 800x600 mm) and the center of gravity of the lifted load. Use this to plan your garage layout.
The GTE 2500 is designed specifically for wheel and tire lifting, not for vehicle chassis lifting. Never use it as a vehicle lift.
| Parameter | Specification | | :--- | :--- | | | Hofmann DuoLift GTE 2500 | | Lifting Capacity | 2500 kg (5500 lbs) | | Overall Weight | approx. 680 kg | | Lifting Height | 1965 mm | | Lifting Time (full height) | approx. 45 seconds | | Overall Width | 3260 mm | | Width Between Columns | 2750 mm | | Passage Width | 2560 mm | | Column Height | 2580 mm | | Minimum Vehicle Ground Clearance | 105 mm | | Motor Power | 3 kW / 4 HP | | Power Supply Requirement | 400-415V, 3-phase, 50/60 Hz | | Min. Concrete Strength / Thickness | B25 / 150 mm (base plate thickness) | | Foundation Plate Dimensions | 3700 x 1300 mm | hofmann duolift gte 2500 manual
Failure to follow these instructions may result in vehicle fall, severe injury, or death.
Clear all tools, jacks, and personnel from under the vehicle. The GTE 2500 is designed specifically for wheel
A detailed Spare Parts Diagram for the GTE 2500 and related models is available at Hebebühnen Ersatzteile.
A screw thread type lift where two screw jacks are linked via a chain in the base frame. Safety Mechanisms: 680 kg | | Lifting Height | 1965
Check the electronic synchronization board (if equipped) or inspect the mechanical leveling cables. Re-sync according to the manual's calibration sequence. Issue 2: The lift stops halfway up and won't go higher
Werner-von-Siemens-Str. 2, 64319 Pfungstadt, Germany Tel: +49 6157 949-0 Email: service@hofmann-germany.de
Max lifting travel of 1800 mm with a lifting time of approximately 45 seconds.
Torque anchor bolts strictly to the manufacturer's specification (usually between 80 to 120 Nm depending on the bolt grade). 3. Structural Design and Components