Leica Tcr805 Total Station User Manual Work [verified] File

Create a new "Job" or select an existing one to store your points.

Stakeout mode is used to find the physical location of predetermined coordinates on the ground. Go to and select Stakeout . Select the data job containing the design coordinates. Enter or select the Point ID that you want to stake out. The screen will display (the angle you need to turn) and (the distance to move). Rotate the total station until reads 0°00'00" . Lock the horizontal motion. Direct the prism holder to stand along this line of sight. Sight the prism and press DIST . Look at the screen indicators: Fill/Cut: Tells you to build up or dig down the ground.

Triggers a distance measurement and automatically saves the data in one step. This is the fastest method for topo shots. Switching Between Prism and Reflectorless Mode Press the USER key (or navigate to the EDM settings menu). leica tcr805 total station user manual work

Extend the tripod legs to a comfortable working height and tighten the leg clamps securely.

Keep spare batteries warm in a pocket; cycle charges completely. Create a new "Job" or select an existing

Internal storage for up to 18,000 measurement points or 8,000 fixpoints. Durability:

Adjust the tripod leg heights to center the circular bubble vial. Select the data job containing the design coordinates

Understanding the physical interface and accuracy limits ensures optimal data collection. Key Specifications : 5 arc-seconds.

| Error Code | Message | Cause | User Manual Solution | | :--- | :--- | :--- | :--- | | | Vertical angle out of limits | Instrument was bumped or leveled poorly. | Re-level. Run vertical index calibration. | | Err 41 | EDM signal too weak | Dirty prism or foggy atmosphere. | Clean the prism. Switch to reflectorless for short range. | | Err 55 | Memory full | Internal storage has 0 bytes free. | Transfer data to PC. Delete old jobs. | | Battery Low | --- | Voltage dropped below 7.0V. | Replace battery. Do not attempt to measure angles. | | No target | --- | Laser not returning in RL mode. | Angle of incidence too steep. Move to a more perpendicular position. |

The electronic level and laser plummet screen will automatically appear upon startup, or you can access it via the functions menu.