Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Work !free! Jun 2026
: Briefly press the blue button, transmit with the remote, and press the blue button again to save the device. 3. Maintenance and Safety
Slide the door manually until the internal locking mechanism clicks back into the track carriage. Page 10: Long-Term Maintenance Protocols
To adjust how easily the door reverses when hitting something, hold the red button for five seconds and use the +/- buttons to set the level. : Briefly press the blue button, transmit with
| Parameter | Value (PR70-07 / PR70-DL) | |-----------|---------------------------| | Mains power supply | 230 Vac 50 Hz | | Motor power supply | 24 V dc | | Max. power input | 260 W | | Max. input current | 8.5 A | | Input power to line (230V) | 1.2 A | | Thrust | 650 N | | Lubrication | Grease | | Encoder | Yes (built-in) | | Speed | 0.10 – 0.18 m/s | | Work cycles | 50% | | Nominal work time | 13 min | | Courtesy light | 24 Vdc (internal) | | Operating temperature | -20°C to +70°C | | Protection class | IP20 | | Motor insulation class | F | | Assembly | Horizontal ceiling-mounted on dedicated runner | | Dimensions (L×W×H) | 442 × 213 × 142 mm | | Weight | 6.7 kg | | Max leaf surface area | 11.5 m² | | Maximum door width | 5 m (for perfectly balanced doors) |
Before performing any installation or maintenance, ensure the power supply is disconnected and locked out. Page 10: Long-Term Maintenance Protocols To adjust how
: Inspect door hardware, springs, and hinges for wear. Troubleshooting Guide Motor does not move No power supply Check circuit breakers and fuses Door opens but won't close Photocell obstruction Clean lenses or realign sensors Short remote range Low battery Replace remote transmitter battery Motor runs, door stationary Manual release active Re-engage the trolley release lever
Verify the ceiling structure can support the weight of the motor rail. Required Tools Electric drill and masonry bits Socket wrench set Screwdrivers (Phillips and flathead) Measuring tape and spirit level Wire strippers 3. Assembling the Guide Rail input current | 8
The primary 230V AC electrical feed line must be run and wired exclusively by a certified professional electrician.